A DCF, step by step
By Investor Wisdom Daily Team·
Would you pay $1,000 today for $1,100 next year?
Section titled “Would you pay $1,000 today for $1,100 next year?”Suppose a hypothetical friend, Priya, offers you a deal: hand over $1,000 now and she will pay you $1,100 in exactly one year, guaranteed. Is it a good deal? It depends on what else your $1,000 could earn. If you could earn 9% a year elsewhere with similar risk, $1,100 next year is worth $1,100 ÷ 1.09 ≈ $1,009.17 today, a little more than you would pay. If you need 12% to take the risk, it is worth only $1,100 ÷ 1.12 ≈ $982.14, less than you would pay. Same promise, different answer, because your required return changed.
A discounted cash flow model is that question asked about a whole business, over many years and with far less certainty than Priya’s guarantee.
What a DCF tries to answer
Section titled “What a DCF tries to answer”A discounted cash flow (DCF) model asks one question: what is all the cash a business will produce in the future worth today? It rests on two ideas. Cash later is worth less than cash now, so every future amount is shrunk (discounted). And a business keeps producing cash after any forecast window ends, so the model adds a “terminal value” for everything beyond it.
There is no official formula sheet for DCF. This lesson builds it from first principles, using one tool throughout: the present value of an amount received in year t is that amount divided by (1 + r) raised to the power t, where r is the discount rate.
At a 9% discount rate, the shrink factor (called the discount factor, 1 ÷ 1.09 raised to the power t) for each year is:
| Year | Discount factor at 9% | $100 received that year is worth today |
|---|---|---|
| 1 | 0.9174 | about $91.74 |
| 2 | 0.8417 | about $84.17 |
| 3 | 0.7722 | about $77.22 |
| 4 | 0.7084 | about $70.84 |
| 5 | 0.6499 | about $64.99 |
Cash five years out is worth only about 65 cents on the dollar today at this rate. Keep that table in mind; everything below is just these factors applied to bigger numbers.
Everything below uses a fully hypothetical business, “Company X”, in millions of dollars. Every input is a labelled assumption. The projections are assumptions chosen to teach the method, not forecasts of any real company.
Worked example: Company X in four steps
Section titled “Worked example: Company X in four steps”Step 1: Pick a cash measure and project five years
Section titled “Step 1: Pick a cash measure and project five years”DCF models usually start from free cash flow (FCF): cash from operations minus capital spending. The SEC’s beginner guide (accessed November 2026) notes that a cash flow statement “can tell you whether the company generated cash” (SEC), which is why it is the natural starting point. Our cash flow statement lesson shows where FCF comes from.
Assumption A: Company X’s FCF is 100 in year 1 and grows 6% a year for five years.
| Year | FCF (assumed) |
|---|---|
| 1 | 100.00 |
| 2 | 106.00 |
| 3 | 112.36 |
| 4 | 119.10 |
| 5 | 126.25 |
In real work you would ground this in the company’s filings and management’s discussion. The SEC describes that discussion as “intended to help investors to see the company through the eyes of management.” Even so, any five-year path is a guess.
Step 2: Choose a discount rate
Section titled “Step 2: Choose a discount rate”Assumption B: a 9% discount rate. Here it stands for the yearly return an investor requires to take on this company’s risk. Because this FCF is cash available to all capital providers, the matching rate blends the cost of debt and equity (often called WACC). Professionals often derive it from the cost of debt and equity; that derivation is out of scope. What matters is that the rate is a choice, and a higher rate means a lower value, exactly as in Priya’s deal.
Step 3: Estimate a terminal value
Section titled “Step 3: Estimate a terminal value”Five years of cash is not the whole business. The common shortcut is a growing perpetuity (a stream of cash assumed to continue forever, growing at a fixed rate): assume cash grows forever at a modest rate g after year 5. The terminal value at the end of year 5 is year-5 FCF times (1 + g), divided by (r - g).
Assumption C: terminal growth of 2.5%.
Terminal value = 126.25 x 1.025 / (0.09 - 0.025) = 1,990.83.
This only works when the discount rate is above the growth rate. If g equals or exceeds r, the denominator hits zero or turns negative and the formula breaks. Terminal growth should also stay at or below the long-run growth of the wider economy; no company outgrows it forever.
Step 4: Discount and add up
Section titled “Step 4: Discount and add up”Now bring every amount back to today at 9%. This example assumes each year’s cash arrives at year-end. Some analysts use a mid-year convention, which raises the value slightly.
| Item | Amount | Value today |
|---|---|---|
| Year 1 FCF | 100.00 | 91.74 |
| Year 2 FCF | 106.00 | 89.22 |
| Year 3 FCF | 112.36 | 86.76 |
| Year 4 FCF | 119.10 | 84.37 |
| Year 5 FCF | 126.25 | 82.05 |
| Years 1-5 subtotal | 563.71 | 434.15 |
| Terminal value | 1,990.83 | 1,293.90 |
| Total | 1,728.05 |
Under these assumptions, the model puts Company X’s operations at about 1,728 million. That is an output of the assumptions, not a fair price for anything. This is enterprise value, the worth of the whole business. To get the value of the shares you would subtract net debt (debt minus cash) and other non-equity claims such as preferred stock and minority interests.
Look at the split: the five forecast years supply only about 25.1% of the total. The terminal value supplies about 74.9%. Most of the answer rests on what you assumed about the years you did not model in detail.
From the whole business to one share
Section titled “From the whole business to one share”Suppose, purely as a further assumption, Company X has net debt of 300 million, no other non-equity claims, and 50 million shares. Equity value is 1,728.05 − 300 = 1,428.05 million, and dividing by 50 million shares gives about $28.56 a share. That per-share figure inherits every assumption above plus two more, so it is a model output, not a price target.
Why small changes swing the answer
Section titled “Why small changes swing the answer”Change one assumption at a time and watch the total:
| Change (others held fixed) | Value | vs base 1,728.05 |
|---|---|---|
| Discount rate 8% | 2,047.41 | +18.5% |
| Discount rate 10% | 1,494.00 | -13.5% |
| Terminal growth 2% | 1,629.77 | -5.7% |
| Terminal growth 3% | 1,842.72 | +6.6% |
A single point on the discount rate moves the value by about a seventh to a fifth (−13.5% to +18.5%). Two forces combine. First, the terminal value’s denominator (r - g) is only 6.5 points wide, so one point is about 15.4% of it. Second, the rate also discounts every year’s cash. The effect is lopsided too: cutting the rate by a point adds more value than raising it by a point removes.
Notice also that terminal growth matters less than the discount rate here, but it is still an input that is easy to stretch, because a slightly higher number feels harmless. Every half-point you add quietly raises the value of years that nobody can see clearly.
The practical lesson is to report a range, not a single number. A DCF that says “1,728” sounds precise; one that says “roughly 1,500 to 2,050 depending on the discount rate” is more honest.
Edge case: terminal growth just under the discount rate
Section titled “Edge case: terminal growth just under the discount rate”What happens if someone sets terminal growth at 8.5%, only half a point below the 9% rate? The denominator shrinks to 0.09 − 0.085 = 0.005, and the terminal value explodes to 126.25 x 1.085 / 0.005 ≈ 27,395.75. Discounted to today that is about 17,805.36, and the total becomes about 18,239.51, roughly 10.55 times the base case, from a change in one input. Nothing about the business changed; the model simply assumed near-endless rapid growth. When a DCF’s terminal value dwarfs everything else this badly, the assumption is the problem, not the company.
Try it: see a discount factor appear
Section titled “Try it: see a discount factor appear”Discounting is compounding run backward, so the compound interest calculator can show you a discount factor. Enter a starting amount of 100, a monthly deposit of 0, 5 years and a 9% annual return (leave inflation and tax at 0). The calculator compounds monthly, so it shows about 156.57. The DCF table compounds once a year: 100 x 1.09^5 ≈ 153.86, and 100 ÷ 153.86 ≈ 0.6499 is the year-5 discount factor above. The gap between 156.57 and 153.86 is a reminder that timing conventions change results. Then try 8% and 10% and watch how much the five-year figure moves; that is the same sensitivity the DCF table shows.
Where the inputs come from in real filings
Section titled “Where the inputs come from in real filings”A DCF is only as good as its inputs, and for a US public company most of them start in its annual report on Form 10-K. The SEC’s investor bulletin How to Read a 10-K (accessed November 19, 2026) says Item 8 contains the “audited financial statements”, including the statement of cash flows, which gives you historical operating cash flow and capital spending. It also says the MD&A in Item 7 covers “any known trends or uncertainties that could materially affect the company’s results”. Those trends are where a careful growth assumption begins, and the bulletin’s note that “critical accounting judgments” can have “a significant impact on the numbers” is a reminder that even the starting cash flows involve estimates.
Limits and common mistakes
Section titled “Limits and common mistakes”- Garbage in, garbage out. The output is only as good as the assumptions, and the future is uncertain.
- Terminal growth too high. Growth near or above the discount rate produces absurd or broken values, as the edge case shows.
- Mixing enterprise value and equity value. Comparing the 1,728.05 enterprise value with the value of the shares alone skips the net debt step.
- Negative or cyclical cash flow. The simple model struggles when FCF is negative or swings sharply with the economy.
- False precision and price-target thinking. Decimal places do not make a guess more accurate. A DCF value shows what your assumptions imply; it is not a fair price, a price target or a signal to trade.
Quick check
Section titled “Quick check”- What is $500 received in two years worth today at a 10% discount rate?
Answer to question 1: present value of one payment
500 ÷ 1.1^2 ≈ 413.22. Divide by 1.1 once for each year of waiting.
- Year-5 FCF is 50, terminal growth is 2% and the discount rate is 8%. What is the terminal value at the end of year 5?
Answer to question 2: growing-perpetuity terminal value
50 x 1.02 ÷ (0.08 − 0.02) = 850. Remember this is a value at year 5; it still has to be discounted back to today.
- Why does the terminal value formula break if terminal growth equals the discount rate?
Answer to question 3: when r equals g
The denominator (r − g) becomes zero, so the formula divides by zero. Even growth just below the rate produces huge, unbelievable values, as the 8.5% edge case shows.
- A DCF gives an enterprise value of 1,000. Net debt is 200 and there are 40 shares. What is the model’s value per share?
Answer to question 4: enterprise value to value per share
(1,000 − 200) ÷ 40 = 20 per share. Subtract net debt first; dividing enterprise value straight by shares overstates the per-share figure.
Key takeaways
Section titled “Key takeaways”- A DCF adds up the value today of projected cash plus a terminal value.
- In this example the terminal value is about three-quarters of the total.
- The discount rate and terminal growth drive the result most, and growth close to the rate breaks the model.
- Subtract net debt to move from enterprise value to equity value.
- Show a sensitivity table and a range, and keep projections labelled as assumptions.
For the basics of what a share represents, see What is a stock?, and for how long-term thinking differs from trading, see Investing vs trading.
Next steps
Section titled “Next steps”- Reverse DCF runs this same model backward to find the growth a given value assumes.
- Walking through a cash flow statement shows where free cash flow comes from.
- The compound interest calculator lets you test discount factors yourself.
Key terms
For educational purposes only. This material does not provide investment advice.